Oil Temperature Sensor For ECM: Service and Repair

2007 Subaru Forester F4-2.5L SOHCSECTION Service and Repair
Oil Temperature Sensor0m

REMOVAL





1. Disconnect the ground cable from battery.
2. Remove the air intake chamber.
3. Remove the engine harness connector from the bracket.
4. Disconnect the connector from the oil temperature sensor.




5. Remove the oil temperature sensor.

INSTALLATION

Install in the reverse order of removal.

Tightening torque: 18 N.m (1.8 kgf.m, 13.3 ft.lb)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.