Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Subaru Outback RFACTORY OEM SERVICE PROCEDURE
Extension Case: Installation
- Attach the selected reduction driven gear shim to end surface of reduction driven gear with Vaseline. < Ref. to ADJUSTMENT , Reduction Driven Gear. >
- Install the extension case.NOTE: Use a new gasket.
Tightening torque: 25 N.m (2.5 kgf-m, 18 ft-lb)
- Install the rear vehicle speed sensor.
Tightening torque: 7 N.m (0.7 kgf-m, 5.2 ft-lb)
- Install the transmission assembly.
< Ref. to INSTALLATION , Automatic Transmission Assembly. >
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.