Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Curtain Airbag Module: Inspection
Perform the inspection of following items, and replace the damaged parts with new ones. < Ref. to , CURTAIN AIRBAG MODULE , INSPECTION, Inspection Locations After a Collision. >
- With side collision (when curtain airbag is deployed)
- Curtain airbag module assembly
- Roof trim
- Front pillar upper trim
- Center pillar upper trim
- Rear quarter pillar trim
- Airbag guide A, B, C
- Other replacement parts, which found to be damaged by visual check
- Assist grip
- Assist grip bracket
- Curtain airbag harness and connector on body side.
- With side collision (when curtain airbag is not deployed)
Check the roof trim, pillar trim and airbag module visually, and then replace them with new ones if damaged or cracked.
Specially inspect the damage of airbag module body, mounting bracket, harness connector.
- Without side collision (dirt and damage of cover) Replace the corresponding part with a new one.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.