Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2005OUTBACK I, STANDARDREPAIR AND DIAGNOSISRESTRAINTSAIR BAG, SRSAIRBAG SYSTEMAIRBAG CONTROL MODULEREMOVAL
2005 Subaru Outback i, Standard
Airbag Control Module: Removal
2005 Subaru Outback i, StandardSECTION Removal
CAUTION:
- Do not disassemble the airbag control module.
- If the airbag control module is deformed or if water damage is suspected, replace the airbag control module with a new one.
- Do not drop the airbag control module.
- After removal, keep the airbag control module on a dry, clean surface away from moisture, heat and dust.
- Turn the ignition switch to OFF.
- Disconnect the ground cable from battery and wait for at least 20 seconds before starting work.
- Remove the console front panel and console side garnish. < Ref. to REMOVAL , Center Console. >
- Remove the screws and pull out the audio unit assembly to disconnect the connector for removal.
- Disconnect the connector from airbag control module.
- Remove the bolts and remove airbag control module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.