Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2005OUTBACK I, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 44 (HVAC SYSTEM (HEATER, VENTILATOR AND A/C))COMPRESSORINSTALLATION
2005 Subaru Outback i, Standard
Section 44 (HVAC System (Heater, Ventilator And A/C)): Compressor: Installation
2005 Subaru Outback i, StandardSECTION Installation
WARNING: This page is about a different car, the 2005 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
- Install in the reverse order of removal.
- Replace O-rings on low-/high-pressure hoses with new ones, then apply compressor oil.
- When replacing compressor, adjust amount of compressor oil. < Ref. to , COMPRESSOR OIL . >
- Charge refrigerant. < Ref. to
, OPERATION , Refrigerant Charging Procedure. >
Tightening torque:
Refer to AIR CONDITIONING UNIT , Component, General Description.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.