SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2005OUTBACK I, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - ENGINE (DIAGNOSTICS) (H4SO)OBD-II GENERAL SCAN TOOLOPERATIONHOW TO USE OBD-II GENERAL SCAN TOOL
2005 Subaru Outback i, Standard

How To Use OBD-II General Scan Tool

2005 Subaru Outback i, StandardSECTION How To Use OBD-II General Scan Tool
  1. Prepare a general scan tool (OBD-II general scan tool) required by SAE J1978.
  2. Open the cover and connect the OBD-II general scan tool to data link connector located in the lower portion of instrument panel (on the driver's side).
    Fig 1: Identifying Location Of Data Link Connector
    G03828409Courtesy of SUBARU OF AMERICA, INC.
  3. Using the OBD-II general scan tool, call up DTC and freeze frame data.

    OBD-II general scan tool functions consist of:

    1. MODE $01: Current powertrain diagnostic data
    2. MODE $02: Powertrain freeze frame data
    3. MODE $03: Emission-related powertrain DTC
    4. MODE $04: Clear/Reset emission-related diagnostic information
    5. MODE $06: Request on-board monitoring test results for non-continuously monitored systems
    6. MODE $07: Request on-board monitoring test results for continuously monitored systems
    7. MODE $09: Request vehicle information

Read out the data according to repair procedures. (For detailed operation procedures, refer to the operation manual of OBD-II general scan tool.)

NOTE: For details concerning DTC, refer to LIST OF DIAGNOSTIC TROUBLE CODE DTC .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.