Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2005OUTBACK I, STANDARDREPAIR AND DIAGNOSISENGINE MECHANICALTIMING BELTENGINE MECHANICAL (H4SO)TIMING BELT COVERINSTALLATION
2005 Subaru Outback i, Standard
Timing Belt Cover: Installation
2005 Subaru Outback i, StandardSECTION Installation
- Install the front timing belt cover.
Tightening torque:
5 N.m (0.5 kgf-m, 3.6 ft-lb)
- Install the timing belt cover (LH).
Tightening torque:
5 N.m (0.5 kgf-m, 3.6 ft-lb)
- Install the crank pulley. < Ref. to , INSTALLATION , Crank Pulley. >
- Install the V-belts. < Ref. to , INSTALLATION , V-belt. >
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.