Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2005OUTBACK I, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSSECURITY AND LOCKSSECURITY SYSTEMINSPECTIONCHECK SECURITY SYSTEM CONDITION MEMORY
2005 Subaru Outback i, Standard
Check Security System Condition Memory
2005 Subaru Outback i, StandardSECTION Check Security System Condition Memory
- Remove the key from ignition switch.
- Close all the doors, trunk lid and rear gate.
- Open the hood.
- Press the LOCK button of transmitter, and then wait until the security indicator light flashes twice for 0.5 sec at intervals of 2 seconds.
- Disconnect the ground cable from battery.
- Connect the battery ground cable to battery.
- Check that the security indicator light blinks twice within 0.5 seconds in 2 seconds cycle. When it does not blink, replace the body integrated unit.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.