Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2005OUTBACK I, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALFUEL SYSTEMFUEL INJECTION (FUEL SYSTEMS) (H4SO)FUEL PUMPINSTALLATION
2005 Subaru Outback i, Standard
Fuel Pump: Installation
2005 Subaru Outback i, StandardSECTION Installation
Install in the reverse order of removal.
NOTE:
Use a new gasket.
- Ensure the sealing portion is free from fuel or foreign particles before installation.
- Tighten the nuts to specified torque in the order as shown in Fig 1 .
Tightening torque:
4.4 N.m (0.45 kgf-m, 3.2 ft-lb)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.