Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
VDC Sequence Control With SUBARU Select Monitor
2005 Subaru Outback i, StandardSECTION VDC Sequence Control With SUBARU Select Monitor
NOTE:
In the event of any trouble, the sequence control may not be operative.
- Connect the Subaru Select Monitor to data link connector under the driver's side instrument panel lower cover.
- Turn the ignition switch to ON.
- Set the Subaru Select Monitor switch to ON.
- Set the Subaru Select Monitor to the "Brake Control" mode.
- When the "VDC Inspection Mode" is selected from the "Function check sequence" menu, the "VDC sequence control" will start.
- Since "Press the [YES] key" is displayed, press the YES key.
- Operation points will be displayed on the Subaru Select Monitor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.