SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2005OUTBACK I, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSGLASS/WINDOWS/MIRRORSWIPER DEICER SWITCHINSPECTIONWITH SUBARU SELECT MONITOR
2005 Subaru Outback i, Standard

With SUBARU Select Monitor

2005 Subaru Outback i, StandardSECTION With SUBARU Select Monitor
CAUTION: Check that the wiper deicer timer is in initial setting or customize setting before inspection.
STEP CHECK LIST

Step Check Yes No
1. CHECK INPUT SIGNAL TO BODY INTEGRATED UNIT. 

When the wiper deicer switch is operated, check the input signal using Subaru Select Monitor.

  1. Connect the Subaru Select Monitor to data link connector.
  2. Turn the ignition switch to ON.
  3. Select {Body Integrated Unit} from << Main Menu <<.
  4. Select {Current Data Display & Save}.
  5. When the wiper deicer switch is set to ON, check the input signal.
 After the wiper deicer switch is set to ON, does it turn to OFF in 15 minutes? Or does it operates continuously? END. Replace the body integrated unit. < Ref. to REMOVAL , Body Integrated Unit. >
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.