Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2004OUTBACK LIMITED, 4D SEDAN, EJ259REPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCK BRAKE CONTROL SYSTEM - VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS)CLEAR MEMORY MODEOPERATIONWITHOUT SUBARU SELECT MONITOR
2004 Subaru Outback Limited, 4D Sedan, EJ259
Without SUBARU Select Monitor
2004 Subaru Outback Limited, 4D Sedan, EJ259SECTION Without SUBARU Select Monitor
- After calling up a diagnostic trouble code (DTC), disconnect diagnosis connector terminal 8 from diagnosis terminal.
- Repeat 3 times within approx. 12 seconds; connecting and disconnecting terminal 8 and diagnosis terminal for at least 0.2 seconds each time.
NOTE:
After diagnostics is completed, make sure to clear memory. Make sure only start code (11) is shown after memory is cleared.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.