Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2004OUTBACK LIMITED, 4D SEDAN, EJ259REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEENGINE CONTROL SYSTEMSFUEL INJECTION (FUEL SYSTEMS) (H4SO)CAMSHAFT POSITION SENSORREMOVAL
2004 Subaru Outback Limited, 4D Sedan, EJ259
Camshaft Position Sensor: Removal
2004 Subaru Outback Limited, 4D Sedan, EJ259SECTION Removal
- Disconnect ground cable from battery.
- Disconnect connector from camshaft position sensor.
- Remove bolt which installs camshaft position sensor to camshaft position sensor support.
- Remove bolt which installs camshaft position sensor support to camshaft cap LH.
- Remove camshaft position sensor and camshaft position sensor support as a unit.
- Remove camshaft position sensor from camshaft position sensor support.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.