Automatic System Torque Specifications

2004 Subaru Outback Base, 4D Wagon, EJ251, StandardSECTION Automatic System Torque Specifications
TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Compressor Bracket Bolts
2.5L 26 (35)
3.0L 24 (33)
Compressor Bracket-To-Compressor Bolts 21 (29)
Condenser/Receiver Drier Pipe-To-Condenser Bolt 11 (15)
High-Pressure Hose-To-Condenser Bolt 11 (15)
High-Pressure & Low-Pressure Hose-To-Compressor Bolts 11 (15)
Idler Pulley Bracket Bolt/Nut 17 (23)
INCH Lbs. (N.m)Β 
Compressor Belt Cover Bolts (Non-Turbo Model) 66 (7.4)
Condenser Bolt 66 (7.4)
Condenser/Receiver Drier Pipe-To-Receiver Drier Bolt 66 (7.4)
Heater Case Bolt/Nut 66 (7.4)
Intake Unit Case Lower Bolt/Upper Nut 66 (7.4)
Receiver Drier Bolt 66 (7.4)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.