Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2004OUTBACK BASE, 4D WAGON, EJ251, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSSECURITY AND LOCKSKEYLESS ENTRY CONTROL MODULEREMOVAL
2004 Subaru Outback Base, 4D Wagon, EJ251, Standard
Keyless Entry Control Module: Removal
2004 Subaru Outback Base, 4D Wagon, EJ251, StandardSECTION Removal
- Disconnect ground cable from battery.
- Remove glove box. Refer to REMOVAL , Glove Box.
- Remove nut, then remove keyless entry control module (B) and the other electrical control module (A) while disconnecting connector.
- Disconnect keyless entry control module and the other control module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.