SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2004OUTBACK BASE, 4D WAGON, EJ251, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTEXTERIOR LIGHTSLIGHTING SYSTEMBACK-UP LIGHT SYSTEMINSPECTIONINHIBITOR SWITCH (A/T)
2004 Subaru Outback Base, 4D Wagon, EJ251, Standard

Inhibitor Switch (A/T)

2004 Subaru Outback Base, 4D Wagon, EJ251, StandardSECTION Inhibitor Switch (A/T)

Measure inhibitor switch resistance.

Fig 1: Measuring Inhibitor Switch Resistance
G03510115Courtesy of SUBARU OF AMERICA, INC.
SWITCH POSITION TERMINAL NO AND STANDARD

Switch position Terminal No. Standard
When select lever is set in "R" position 1 and 2 Less than 1 ohm
Other positions More than 1 Mohm
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.