Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2004OUTBACK BASE, 4D WAGON, EJ251, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSCRUISE CONTROL - MECHANISM & FUNCTIONCRUISE CONTROLCOMMAND SWITCH (CRUISE CONTROL LEVER)NOTES
2004 Subaru Outback Base, 4D Wagon, EJ251, Standard
Command Switch (Cruise Control Lever): Notes
2004 Subaru Outback Base, 4D Wagon, EJ251, StandardSECTION Notes
- When the vehicle is driven with the cruise control activated, the command switch controls its operation. It inputs SET/COAST signal, RESUME/ACCEL signal or CANCEL signal to the cruise control module.
- The command switch is located on the right side of the steering wheel, so the driver can operate it without releasing hands from the steering wheel.
- The command switch is a self-returning lever type.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.