Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2004BAJA BASE, STANDARDREPAIR AND DIAGNOSISSTEERINGPOWER STEERINGPOWER ASSISTED SYSTEM (POWER STEERING)STEERING WHEELREMOVAL
2004 Subaru Baja Base, Standard
Steering Wheel: Removal
2004 Subaru Baja Base, StandardSECTION Removal
NOTE:
Roll connector is also known as Clockspring.
- Disconnect ground cable from battery.
- Set tires to straight-ahead position.
- Remove airbag module. Refer to
REMOVAL & INSTALLATION
, Driver's Airbag Module.WARNING: Always refer to AIR BAG RESTRAINT SYSTEMS before performing airbag module service (if so equipped). .
- Remove steering wheel nut, and then draw out steering wheel from shaft using steering puller.
NOTE:
Make matching marks on steering wheel and steering column in advance.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.