Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2004BAJA BASE, STANDARDREPAIR AND DIAGNOSISENGINE MECHANICALFUEL SYSTEMFUEL INJECTION (FUEL SYSTEMS) (H4SO U5 (PZEV))FUEL SUB LEVEL SENSORREMOVAL
2004 Subaru Baja Base, Standard
Fuel Sub Level Sensor: Removal
2004 Subaru Baja Base, StandardSECTION Removal
WARNING:
- Place "NO FIRE" signs near the working area.
- Be careful not to spill fuel on the floor.
- During work procedures, if fuel tank is more than 3/4 full, be careful because fuel may spill.
- Drain fuel from fuel tank. Refer to FUEL .
- Raise rear seat and turn floor mat up. (Wagon model)
- Remove rear seat. (Sedan model)
- Remove service hole cover.
- Disconnect connector from fuel sub level sensor.
- Disconnect fuel jet pump hose.
- Remove bolts which install fuel sub level sensor on fuel tank.
- Remove fuel sub level sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.