Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2002LEGACY GT WAGON AWD F4-2.5L SOHCREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINSERVICE PRECAUTIONS
2002 Subaru Legacy GT Wagon AWD F4-2.5L SOHC
Transmission and Drivetrain: Service Precautions
2002 Subaru Legacy GT Wagon AWD F4-2.5L SOHCSECTION Service Precautions
C: CAUTION
^ Wear working clothing, including a cap, protective goggles, and protective shoes during operation.
^ Remove contamination including dirt and corrosion before removal, installation or disassembly.
^ Keep the disassembled parts in order and protect them from dust or dirt.
^ Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, installation, disassembly, and replacement.
^ Use SUBARU genuine grease etc. or the equivalent. Do not mix grease etc. with that of another grade or from other manufacturers.
^ Be sure to tighten fasteners including nuts and bolts to the specified torque.
^ Place shop jacks or safety stands at the specified points.
^ Apply grease onto sliding or revolving surfaces before installation.
^ Before installing O-rings or snap rings, apply a sufficient amount of grease to avoid damage and deformation.
^ Before securing a part in a vise, place cushioning material such as wood blocks, aluminum plates, or shop cloths between the part and the vise.
^ Before disconnecting electrical connectors, be sure to disconnect ground cable from battery.
^ Wear working clothing, including a cap, protective goggles, and protective shoes during operation.
^ Remove contamination including dirt and corrosion before removal, installation or disassembly.
^ Keep the disassembled parts in order and protect them from dust or dirt.
^ Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, installation, disassembly, and replacement.
^ Use SUBARU genuine grease etc. or the equivalent. Do not mix grease etc. with that of another grade or from other manufacturers.
^ Be sure to tighten fasteners including nuts and bolts to the specified torque.
^ Place shop jacks or safety stands at the specified points.
^ Apply grease onto sliding or revolving surfaces before installation.
^ Before installing O-rings or snap rings, apply a sufficient amount of grease to avoid damage and deformation.
^ Before securing a part in a vise, place cushioning material such as wood blocks, aluminum plates, or shop cloths between the part and the vise.
^ Before disconnecting electrical connectors, be sure to disconnect ground cable from battery.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.