Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU2002LEGACY GT WAGON AWD F4-2.5L SOHCREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGAMBIENT TEMPERATURE SENSOR / SWITCH HVACSERVICE AND REPAIRAMBIENT SENSOR
2002 Subaru Legacy GT Wagon AWD F4-2.5L SOHC
Ambient Sensor
2002 Subaru Legacy GT Wagon AWD F4-2.5L SOHCSECTION Ambient Sensor
Ambient Sensor
REMOVAL
1. Open front hood.
2. Disconnect ground cable from battery.
3. Disconnect ambient sensor connector.
4. Remove ambient sensor from radiator lower panel.
INSTALLATION
Install in the reverse order of removal.
REMOVAL
1. Open front hood.
2. Disconnect ground cable from battery.
3. Disconnect ambient sensor connector.
4. Remove ambient sensor from radiator lower panel.
INSTALLATION
Install in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.