Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU1998LEGACY BRIGHTON WAGON AWD F4-2.2L SOHCREPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMIGNITION SWITCHDESCRIPTION AND OPERATION
1998 Subaru Legacy Brighton Wagon AWD F4-2.2L SOHC
Ignition Switch: Description and Operation
1998 Subaru Legacy Brighton Wagon AWD F4-2.2L SOHCSECTION Description and Operation
DESCRIPTION
The ignition key warning system is adopted.
- When driver opens the door with the ignition key in "LOOK" or "ACC" position, warning alarm sounds to warn the driver.
In manual transmission vehicle, two stage steering lock is adopted to improve safety in key operation.
- When turning the ignition key from "ACC" to "LOOK" position, it is necessary to push the key into the key cylinder (arrow 1 in the illustration) and then turn the key to "LOCK" position (arrow 2).
Automatic transmission vehicles are equipped with a key interlock mechanism to prevent erroneous operation.
- Ignition key can be turned to "LOCK" position only when select lever is set to P position.
NOTE: If the key cannot be turned to "LOCK" position although select lever is in P position (because of key interlock system failure), the key interlock system must be canceled by key interlock release lever which is located at the lower side of the steering column.
The ignition key warning system is adopted.
- When driver opens the door with the ignition key in "LOOK" or "ACC" position, warning alarm sounds to warn the driver.
In manual transmission vehicle, two stage steering lock is adopted to improve safety in key operation.
- When turning the ignition key from "ACC" to "LOOK" position, it is necessary to push the key into the key cylinder (arrow 1 in the illustration) and then turn the key to "LOCK" position (arrow 2).
Automatic transmission vehicles are equipped with a key interlock mechanism to prevent erroneous operation.
- Ignition key can be turned to "LOCK" position only when select lever is set to P position.
NOTE: If the key cannot be turned to "LOCK" position although select lever is in P position (because of key interlock system failure), the key interlock system must be canceled by key interlock release lever which is located at the lower side of the steering column.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.