Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU1998LEGACY BRIGHTON WAGON AWD F4-2.2L SOHCREPAIR AND DIAGNOSISSTARTING AND CHARGINGBATTERYSERVICE AND REPAIRREMOVAL AND INSTALLATION
1998 Subaru Legacy Brighton Wagon AWD F4-2.2L SOHC
Removal and Installation
1998 Subaru Legacy Brighton Wagon AWD F4-2.2L SOHCSECTION Removal and Installation
1. Disconnect the positive (+) terminal after disconnecting the negative (-) terminal of battery.
2. Remove flange nuts from battery rods and take off battery holder.
3. Remove battery.
Tightening torque:
3.4 ± 1.0 N.m (0.35 ± 0.1 kg-m, 2.5 ± 0.7 ft-lb)
NOTE:
- Clean battery cable terminals and apply grease to retard the formation of corrosion.
- Connect the positive (+) terminal of battery and then the negative (-) terminal of the battery.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.