Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU1998LEGACY BRIGHTON WAGON AWD F4-2.2L SOHCREPAIR AND DIAGNOSISDIAGRAMSELECTRICAL DIAGRAMSLIGHTING AND HORNSEXTERIOR LIGHTING MODULE
1998 Subaru Legacy Brighton Wagon AWD F4-2.2L SOHC
Exterior Lighting Module
1998 Subaru Legacy Brighton Wagon AWD F4-2.2L SOHCSECTION Exterior Lighting Module
Lighting System (Clearance Light And Illumination Light) (LHD Model) Circuit 1:
Lighting System (Clearance Light And Illumination Light) (LHD Model) Circuit 2:
Lighting System (Clearance Light And Illumination Light) (RHD Model) Circuit 1:
Lighting System (Clearance Light And Illumination Light) (RHD Model) Circuit 2:
Fuse/Relay Locations: For fuse and/or relay locations refer to Starting and Charging / Power and Ground Distribution: Power and Ground Distribution
Ground Locations: For ground locations refer to Vehicle / Locations / Harness: Ground Locations
Connector Locations: For connector locations refer to Vehicle / Locations / Connectors: Connector Locations
Component Locations: For component locations refer to Vehicle / Locations / Harness: Harness Locations
NOTE:
To locate Connectors, Components and/or Grounds using Harness Connector Location diagram(s) use the connector's alphanumeric name [referred to in the wiring diagram(s)] to identify the apropriate Harness Connector Location diagram. For example, the prefix letter "B" in the connector name "B-38" indicates the location is displayed in the Bulkhead Wiring Harness Connector Location diagram.
Legend:
Prefix Harness Connector Diagram
F Front
B Bulkhead
i Instrument Panel
P Power Window
D Door
R Rear
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.