Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU1998FORESTER L, STANDARDREPAIR AND DIAGNOSISQUICK LOOKUPSELECTRICAL COMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORMISCELLANEOUS
1998 Subaru Forester L, Standard
Electrical Component Locator: Miscellaneous
1998 Subaru Forester L, StandardSECTION Miscellaneous
MISCELLANEOUS
| Component | Component Location |
|---|---|
| A/T Dropping Resistor | On right side of engine compartment. |
| Blower Motor Resistor | Behind right side of dash. |
| Check Connector | Under left side of dash. |
| Data Link Connector (DLC) | On dash, left of steering column. See Figure. |
| Diagnosis Connector | Behind left side of dash. |
| Diagnosis Terminal (Ground) | Behind left side of dash. |
| Diode (Luggage Room Light) | At right rear corner of cargo compartment. |
| Ignition Coil | On top center of engine. See Figure. |
| Ignitor | On center of firewall. See Figure. |
| Mirror Heater Condenser | Behind right side of dash. |
| Shield Joint Connector (ABS) | At right front corner of engine compartment. |
| Shield Joint Connector (A/T) | Behind left side of dash. |
| Shield Joint Connector (E/G) | Behind right kick panel. |
| Test Mode Connector | Behind left side of dash. See Figure. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.