Ignition Coil Resistance

1994 Subaru Legacy L, 4D Sedan, FWD, StandardSECTION Ignition Coil Resistance
  1. Disconnect 3-wire connector from ignition coil assembly. Using an ohmmeter, check primary resistance between terminals No. 1 and 2 for one coil. See Fig 1 .
  2. Check primary resistance between terminals No. 2 and 3 for remaining coil. Resistance should be as specified. See IGNITION COIL RESISTANCE table. If resistance is not as specified for each coil, replace ignition coil assembly.
  3. To test secondary resistance, connect one ohmmeter lead to tower at one end of coil. Connect remaining ohmmeter lead to tower at opposite end of same coil.
  4. Repeat test for other coils. If resistance of each coil is not as specified, replace ignition coil assembly.
Fig 1: Ignition Coil Connector Terminal ID
G93I80000Courtesy of SUBARU OF AMERICA, INC.
IGNITION COIL RESISTANCE - OHMS @ 68°F (20°C)

Application Primary Secondary
Hitachi 0.70 13,500
Diamond 0.70 21,000
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.