Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU1994LEGACY L, 4D SEDAN, FWD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTSTEERING COLUMN SWITCHESREMOVAL & INSTALLATIONNOTES
1994 Subaru Legacy L, 4D Sedan, FWD, Standard
Removal & Installation: Notes
1994 Subaru Legacy L, 4D Sedan, FWD, StandardSECTION Notes
WARNING:
Disable air bag system before servicing steering column. Failure to disable system could result in accidental air bag deployment and possible personal injury. To disable system, disconnect negative battery cable. Wait at least 10 minutes before servicing steering column to allow system back-up power supply capacitor to discharge. DO NOT connect electrical test equipment to any Yellow harness connector. For more information, see the AIR BAG RESTRAINT SYSTEM article in the ACCESSORIES/SAFETY EQUIPMENT section.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.