4-Cylinder Idle Speed: Legacy

1991 Subaru Legacy L, 4D Sedan, AWD, StandardSECTION Legacy
  1. Ensure air filter is clean, vacuum hoses are properly routed, and timing is correct. Warm engine to operating temperature and attach inductive pick-up tachometer to No. 1 spark plug wire.
    NOTE: Because spark plugs No. 1 and No. 2 fire simultaneously, some tachometers may register twice the actual engine speed.
  2. Check idle speed with all accessories off, then check with all accessories on. If idle speed is not specified in IDLE SPEED SPECIFICATIONS (LEGACY)Β  table, check self-diagnostic system for trouble code(s) and repair as necessary. See G - TESTS W/ CODES article in the ENGINE PERFORMANCE Section.
IDLE SPEED SPECIFICATIONS (LEGACY)

Application RPM
2.2L Accessories Off 600-800
2.2L Accessories On 800-900
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.