Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
EGR System: Operation
EGR valve receives operating vacuum from carburetor ported vacuum (throttle body for fuel injected models). A thermo vacuum valve, used on all carbureted models, bleeds off vacuum to EGR valve when intake manifold temperature is below 86°F (30°C). When intake manifold temperature reaches 104°F (40°C), vacuum bleed off stops and normal EGR operation begins.
To control vacuum bleed off, an EGR leak orifice is used. This vacuum bleed off system is used on MPFI models and, also on Federal models with manual transmissions.
On all fuel injected models, EGR operating vacuum is controlled by a combination of the ECU and the EGR solenoid valve. This system does not allow EGR operation until engine reaches normal operating temperature or at wide open throttle.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.