Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU1987GL-10 4D WAGON, 1.8 4, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMEGR FUNCTION TESTINGCOMPONENT TESTINGEGR VALVE
1987 Subaru GL-10 4D Wagon, 1.8 4, Automatic
EGR Valve
1987 Subaru GL-10 4D Wagon, 1.8 4, AutomaticSECTION EGR Valve
- Look through opening in EGR valve body. With engine at normal operating temperature, check that valve shaft moves when engine reaches 3000-3500 RPM under no-load condition.
- If shaft does not move as specified, remove valve and manually check valve movementfc. If valve appears okay, check vacuum lines for leaks. If valve does not operate, clean or replace.NOTE: When cleaning EGR valve, DO NOT wash in solvent or degreaser or permanent damage to the valve diaphragm will result.
- While holding valve assembly by hand, lightly tap on sides and end of valve with plastic hammer to remove exhaust deposits from the valve seat. DO NOT place unit in a vise.
- Using wire wheel, buff the exhaust deposits from around mounting surface and valve. Depress valve diaphragm, look through valve outlet and inspect valve seat area for cleanliness. Repeat cleaning operation if not completely clean.
- Inspect valve outlet for deposits and clean as necessary. Blow clean with compressed air. Recheck valve operation by applying 7.87 in. Hg with a hand vacuum pump. Install unit using a new gasket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.