Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU1985GL-10 4D WAGON, STANDARDLABOR TIMESOTHER VARIANTTRANSMISSIONAUTOMATIC TRANSTRANSMISSION ASSEMBLYREMOVE, INSTALL, AND OVERHAUL
1985 Subaru GL-10 4D Wagon, Standard
Transmission Assembly: Remove, Install, and Overhaul
1985 Subaru GL-10 4D Wagon, StandardSECTION Remove, Install, and Overhaul
WARNING: This page is about the GL-10 4D Sedan, Automatic, which is a different variant/trim than selected.
3 AND 4 SPEED TRANS
Includes: R&I Transaxle Assembly, inspect and replace necessary Transmission components and road test.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| FWD,3 Spd Trans | 9.8 | A | ||
| Additional Procedure: TRANSMISSION ASSEMBLY: Remove, Install, and Overhaul: | ||||
| Where Air Cond interferes add | 0.4 | A | ||
| Where Pwr Strg interferes add | 0.3 | A | ||
| Combination Procedure: CONVERTER BUSHING: Remove & Replace: | ||||
| 0.7 | B | |||
| Combination Procedure: CONVERTER SEAL: Remove & Replace: | ||||
| 0.4 | B | |||
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| 0.5 | C | |||
| Combination Procedure: OIL PUMP: Remove & Replace: | ||||
| 0.9 | B | |||
| Combination Procedure: SPEEDOMETER DRIVE GEAR: Remove & Replace: | ||||
| 3 Spd Trans | 0.6 | B | ||
| Combination Procedure: SPEEDOMETER DRIVEN GEAR: Remove & Replace: | ||||
| 3 Spd Trans | 0.7 | C | ||
| Combination Procedure: TORQUE CONVERTER: Remove & Replace: | ||||
| 0.3 | C | |||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.