Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUBARU1985GL 4D SEDAN, 1.8 5, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMFEEDBACK CARBURETOR SYSTEMTESTINGSELECTION CODE CHART REPAIR PROCEDURESECM CONNECTOR TERMINAL NO. 45
1985 Subaru GL 4D Sedan, 1.8 5, Standard
ECM connector terminal No. 45
1985 Subaru GL 4D Sedan, 1.8 5, StandardSECTION ECM connector terminal No. 45
For all models except 4WD, cut off harness and tape it open ends. If equipped with a 4-speed man. trans., connect to ground.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.