Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSMART2012FORTWO ELECTRIC DRIVE, 2D COUPEREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALGAUGESELECTRICAL SYSTEM, EQUIPMENT & INSTRUMENTS - TORQUE SPECIFICATIONS
2012 Smart Fortwo Electric Drive, 2D Coupe
Electrical System, Equipment & Instruments - Torque Specifications
2012 Smart Fortwo Electric Drive, 2D CoupeSECTION Electrical System, Equipment & Instruments - Torque Specifications
- Torque Specifications
- Electrical system, equipment and instruments - BA54.00-Z-9999AZ
- Battery
- High-voltage battery
- High-voltage distributor module
- Fuse and relay box
- Fuse and relay box - BA54.15-P-1000-01A
- Fuse and relay box - BA54.15-P-1000-01B
- Fuse and relay box - BA54.15-P-1000-01C
- Fuse and relay box - BA54.15-P-1000-01D
- Fuse and relay box - BA54.15-P-1000-01E
- Fuse and relay box - BA54.15-P-1000-01F
- Fuse and relay box - BA54.15-P-1000-01G
- Fuse and relay box - BA54.15-P-1000-01I
- Fuse and relay box - BA54.15-P-1000-01J
- Fuse and relay box - BA54.15-P-1000-01K
- Fuse and relay box - BA54.15-P-1000-01L
- Cable duct
- Wiring harness
- Control units/base module
- Jacket tube switch module - BA54.25-P-1000-02A
- Signaling system
- Parktronic system - BA54.65-P-1000-01A
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.