Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSCION2016IM AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 2 (MANUAL TRANSMISSION - SERVICE INFORMATION)BACK-UP LIGHT SWITCHINSPECTION [06/2015 - ]PROCEDURE
2016 Scion iM Automatic CVT Trans
Inspection [06/2015 - ]: Procedure
2016 Scion iM Automatic CVT TransSECTION Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT BACK-UP LIGHT SWITCH ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
*a Push *b Release *c Component without harness connected
(Back-up Light Switch Assembly)Standard Resistance
Tester Connection Switch Condition Specified Condition 1 - 2 Pushed Below 1 Ω 1 - 2 Released 10 kΩ or higher If the result is not as specified, replace the back-up light switch assembly.
- Measure the resistance according to the value(s) in the table below.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.