Warning light

2009 Scion xD AutomaticSECTION Warning light
PROBLEM SYMPTOMS CHART - WARNING LIGHT

Symptom Suspected Area See
MIL does not come on Refer to troubleshooting MIL CIRCUIT
Charge warning light does not come on Generator INSPECTION
Wire harness or connector -
Combination meter assembly TERMINALS OF ECU 
Brake warning light does not come on Refer to troubleshooting (Vehicle with ABS) -
Refer to troubleshooting (Vehicle with VSC) BRAKE WARNING LIGHT DOES NOT COME ON
Brake warning light remains on Refer to troubleshooting (Vehicle with ABS) -
Refer to troubleshooting (Vehicle with VSC) BRAKE WARNING LIGHT REMAINS ON
ABS warning light does not come on Refer to troubleshooting (Vehicle with ABS) -
Refer to troubleshooting (Vehicle with VSC) ABS WARNING LIGHT DOES NOT COME ON
ABS warning light remains on Refer to troubleshooting (Vehicle with ABS) -
Refer to troubleshooting (Vehicle with VSC) ABS WARNING LIGHT REMAINS ON
SRS warning light does not come on Refer to troubleshooting SRS WARNING LIGHT DOES NOT COME ON
SRS warning light remains on Refer to troubleshooting SRS WARNING LIGHT REMAINS ON
Open door warning light does not come on CAN communication system HOW TO PROCEED WITH TROUBLESHOOTING
Door courtesy switch circuit DOOR COURTESY SWITCH CIRCUIT
Combination meter assembly TERMINALS OF ECU 
Seat belt warning light for driver seat does not operate Refer to troubleshooting DRIVER SIDE SEAT BELT WARNING LIGHT DOES NOT OPERATE
Seat belt warning light for front passenger seat does not operate Refer to troubleshooting FRONT PASSENGER SIDE SEAT BELT WARNING LIGHT MALFUNCTION
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.