Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSCION2007TC BASE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTI-LOCK BRAKESBRAKES - ABSBRAKE ACTUATOR COMPONENTSINSTALLATION
2007 Scion tC Base, Automatic
Brake Actuator Components: Installation
2007 Scion tC Base, AutomaticSECTION Installation
- INSTALL BRAKE ACTUATOR ASSEMBLY
- Install the brake actuator to the bracket with the 2 nuts.
Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
- Install the brake actuator to the bracket with the 2 nuts.
- INSTALL BRAKE ACTUATOR ASSEMBLY WITH BRACKET
- Install the brake actuator with bracket with the 2 bolts and nut.
Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf)
NOTE:- Be careful not to damage the brake tubes and wire harness.
- Install the bolts and nut in order shown n the illustration.
- Connect the brake actuator connector.NOTE: Make sure that the lever is locked securely.
- Install the brake actuator with bracket with the 2 bolts and nut.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.