Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSCION2006XB L4-1.5L (1NZ-FE)REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSCLUTCH, M/TSYSTEM SPECIFICATIONSTORQUE SPECIFICATION
2006 Scion xB L4-1.5L (1NZ-FE)
Torque Specification
2006 Scion xB L4-1.5L (1NZ-FE)SECTION Torque Specification
Clutch cover bolts 19 Nm (195 kgf-cm, 14 ft. lbs.)
Align the matchmark on the cover with that on the flywheel.
Tighten the 6 bolts in order, and start with the bolt located near the knock pin on the top.
Clutch Disc
Minimum rivet depth 0.3 mm (0.012 inch)
Maximum disc runout 0.8 mm (0.031 inch)
Maximum wear:
Diaphragm spring wear
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.