Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transmission Wire
2006 Scion xB L4-1.5L (1NZ-FE)SECTION Transmission Wire
TRANSMISSION WIRE
INSPECTION
1. INSPECT TRANSMISSION WIRE (ATF TEMPERATURE SENSOR)
a) Disconnect the E1 wire connector.
b) Measure the resistance of the transmission wire.
Standard resistance
HINT: If the resistance is not as specified for either of the ATF temperatures shown in the table, the driveability of the vehicle may decrease.
Standard resistance
INSPECTION
1. INSPECT TRANSMISSION WIRE (ATF TEMPERATURE SENSOR)
a) Disconnect the E1 wire connector.
b) Measure the resistance of the transmission wire.
Standard resistance
Standard resistance:
HINT: If the resistance is not as specified for either of the ATF temperatures shown in the table, the driveability of the vehicle may decrease.
Standard resistance
Standard resistance:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.