Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
2010 Saturn Vue XE, 3.5 N
Quick Lookups: Fluids
2010 Saturn Vue XE, 3.5 NSECTION Fluids
| FLUID CAPACITIES | |||||||
|---|---|---|---|---|---|---|---|
| Fluid Type | Application | Standard | Metric | Fluid Spec | Note | S/H | |
| Air Cond Compressor Oil | 5.00 OZS. | 0.14 L | PAG 46 | S | |||
| Air Cond Refrigerant | 1.26 LBS. | 0.57 KG | R-134a | S | |||
| Automatic Transmission Fluid | 6 Spd Trans | Drain and Refill | N/A | N/A | Automatic Transmission Fluid DEXRON VI | Fluid Capacity is between: 5.3 to 7.4 qts. | S |
| Automatic Transmission Fluid | 6 Spd Trans | Dry | N/A | N/A | Automatic Transmission Fluid DEXRON VI | Fluid Capacity is between: 7.4 - 9.5 qts. | S |
| Automatic Transmission Fluid | 6 Spd Trans | Overhaul | N/A | N/A | Automatic Transmission Fluid DEXRON VI | Fluid Capacity is between: 4.2 to 6.3 qts. | S |
| Brake Fluid | N/A | N/A | DOT 3 Hydraulic Brake Fluid | S | |||
| Differential Gear Oil | Rear Axle | 0.53 QTS. | 0.5 L | SAE 75W-90 Synthetic Gear Oil | S | ||
| Engine Oil | 3.5L Eng | w/Filter | 4.00 QTS. | 3.78 L | API - SAE 5W-20 | Use oil that meets GM Standard GM6094M. For areas of extreme cold, where temperatures fall below -20Deg.F (-29Deg.C), it is recommended a SAE 5W-30 synthetic oil or a SAE 10W-30 oil. Both will provide easier cold starting and better protection for your engine at extremely low temperatures. | S |
| Fuel Tank | 16.70 GALS. | 63.21 L | S | ||||
| Power Steering Fluid | N/A | N/A | GM Power Steering Fluid | GM Part No. 89021184. | S | ||
| Windshield Washer Fluid | N/A | N/A | Optikleen Windshield Washer Fluid | When using concentrated washer fluid, follow the fluid manufacturer's instructions for adding water. | S | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.