Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Body Control Module (BCM) Programming/RPO Configuration: Preparation
2010 Saturn Vue XE, 3.5 NSECTION Preparation
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Understand this entire procedure.
- The battery is fully charged.
- The ignition switch is in the ON position.
- The data link connector (DLC) is accessible.
- All disconnected modules and devices are reconnected before programming.
- Follow all Scan Tool on screen directions.
- Take time to verify the VIN on the Scan Tool is correct, failure to do this could result in the service part being made unprogrammable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.