Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2010 Saturn Vue XE, 3.5 NSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Uncap A/C components.
- Install new sealing washers. Refer to Sealing Washer Replacement .
- Install the liquid line.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
- Install the liquid line and compressor hose to the condenser.
- Install the liquid line and compressor hose bolt to the condenser.
Tighten: Tighten the bolt to 20 N.m (15 lb ft).
- Install the liquid line to the rail clip.
NOTE:
Refer to Fastener Notice
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.