SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2010VUE XE, 3.5 NREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 799 (ENGINE CONTROLS AND FUEL - 2.4L - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSENGINE CONTROL MODULE REPLACEMENT (LAT)
2010 Saturn Vue XE, 3.5 N

Engine Control Module Replacement (LAT)

2010 Saturn Vue XE, 3.5 NSECTION Engine Control Module Replacement (LAT)
WARNING: This page is about a different car, the 2008 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Engine Control Module
GM2030145Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (With LAT) or Battery Negative Cable Disconnection and Connection (Without LAT) .
1 Engine Control Module
NOTE: In order to prevent any possible electrostatic discharge damage to the ECM, do not touch the connector pins or the soldered components on the circuit board.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.