Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Testing
2010 Saturn Vue XE, 3.5 NSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2007 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that the transmitter is the correct transmitter for the vehicle.
- If not the correct transmitter, replace the transmitter.
- Verify the scan tool FOB Programmed parameter is Yes.
- If not Yes, program the transmitter.
- Place the transmitter on the test pad of the J 43241
and press each button of the transmitter one at a time. The tester should sound a tone and illuminate a green light when each button is pressed.
- If none of the buttons sounds the tone and illuminates the green light, replace the battery.
- If one or more of the buttons sounds the tone and illuminates the green light, replace the transmitter.
- Verify the scan tool FOB Function parameter responds to every function on the transmitter.
- If it does not respond to every function, replace the RCDLR module.
- Replace the transmitter.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.