Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Remote Function Component Views
2010 Saturn Vue XE, 3.5 NSECTION Remote Function Component Views
WARNING: This page is about a different car, the 2007 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Sunroof Switch-Open/Close (CF5) |
| 2 | Cellular Microphone (UE1, U3U) |
| 3 | Garage Door Opener Buttons (UG1) |
| 4 | Cellular Microphone (UE1, U3U) |
| 5 | Sunroof Switch-Vent (CF5) |
| 6 | Courtesy Lamp-Overhead Console-Right |
| 7 | Inside Rearview Mirror |
| 8 | Courtesy Lamp Switch-Right |
| 9 | Cellular Microphone (UE1, U3U) |
| 10 | Garage Door Opener Transmitter (UG1) |
| 11 | Cellular Microphone (UE1, U3U) |
| 12 | Courtesy Lamp Switch-Left |
| 13 | Onstar Button Assembly |
| 14 | Inflatable Restraint I/P Module Indicator |
| 15 | Courtesy Lamp Overhead Console-Left |
| Callout | Component Name |
|---|---|
| 1 | Remote Control Door Lock Receiver (RCDLR) |
| 2 | Rear Park Assist Indicator (UD7) |
| 3 | Speaker - RR |
| 4 | Vehicle Communication Interface Module (VCIM) (UE1) |
| 5 | Amplifier (UQA) |
| 6 | Rear Compartment Courtesy Lamp |
| 7 | Speaker - LR |
| Callout | Component Name |
|---|---|
| 1 | Hood Ajar Switch (AP3/AP8) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.