SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2010VUE XE, 3.5 NREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 177 (ENTERTAINMENT SYSTEMS)REPAIR INSTRUCTIONSRADIO REPLACEMENT
2010 Saturn Vue XE, 3.5 N

Radio Replacement

2010 Saturn Vue XE, 3.5 NSECTION Radio Replacement
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Replacing Radio
GM1501462Courtesy of GENERAL MOTORS CORP.
Radio Replacement

Callout Component Name
NOTE: Refer to Fastener Notice in Cautions and Notices.
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .
Radio Assembly Replacement 
1 Panel, I/P Accessory Trim
2 Screw, Radio Assembly (Qty: 4)

Tighten:  2 N.m (18 lb in)
3 Radio Assembly
Tip: 
  1. Loosen the HVAC control enough to let the radio clear the I/P.
  2. Disconnect the antenna cable.
  3. Disconnect the electrical connector.
  4. Perform the radio setup procedure when replacement is complete. Refer to Radio Setup .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.