SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2010VUE XE, 3.5 NREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1274 (KEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONS)DIAGNOSTIC INFORMATION AND PROCEDURESKEYLESS ENTRY SYSTEM MALFUNCTIONCIRCUIT/SYSTEM VERIFICATION
2010 Saturn Vue XE, 3.5 N

Circuit/System Verification

2010 Saturn Vue XE, 3.5 NSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The diagnostic assumes the transmitter worked with the vehicle at one time.

  1. Place the transmitter on the J 43241  Keyless Enter Tester test pad and press each transmitter button one at a time. The tester should sound a tone and illuminate a green light with each button press.
    • If one or more buttons do not function, replace the transmitter battery and retest with the J 43241  Keyless Enter Tester. If the condition continues after battery replacement, replace the transmitter.
  2. Operate the transmitter function while observing the vehicle. The vehicle should perform each of the corresponding functions selected on the transmitter.
    • If any function does not work, program the keyless entry transmitter, refer to Remote Control Door Lock Transmitter Learn . If any function still does not work after reprogramming, replace the transmitter. If any function still does not work after replacing the transmitter, replace the RCDLR.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.