SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2010VUE XE, 3.5 NREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1103 (KEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONS)REPAIR INSTRUCTIONSREMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENT
2010 Saturn Vue XE, 3.5 N

Remote Control Door Lock Receiver Replacement

2010 Saturn Vue XE, 3.5 NSECTION Remote Control Door Lock Receiver Replacement
WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Remote Control Door Lock Receiver
GM1792911Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Drop rear under shelf liner in trunk. Refer to Rear Window Trim Panel Speaker Opening Cover Replacement .
  2. Program the remote control door lock receiver after replacement. Refer to Control Module References .
1 Remote Control Door Lock Transmitter Assembly
Tip: 
  • Reach up through access hole.
  • Working through the access hole, disconnect the electrical connector.
  • Push the two tabs towards the module assembly in order to release the module from the panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.