SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2010VUE XE, 2.4 1REPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTI-LOCK BRAKESANTILOCK BRAKE SYSTEMREPAIR INSTRUCTIONSVEHICLE YAW SENSOR REPLACEMENT
2010 Saturn Vue XE, 2.4 1

Vehicle Yaw Sensor Replacement

2010 Saturn Vue XE, 2.4 1SECTION Vehicle Yaw Sensor Replacement
Fig 1: Vehicle Yaw Sensor
GM1873510Courtesy of GENERAL MOTORS COMPANY
Vehicle Yaw Sensor Replacement

Callout Component Name
WARNING:

Refer to SIR Warning .

Preliminary Procedures

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove front floor rear console. Refer to Front Floor Console Replacement .
1 Electronic Brake Control Vehicle Yaw Sensor Bolt (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
8 N.m (71 lb ft)
2 Electronic Brake Control Vehicle Yaw Sensor Assembly

Procedure

  1. Remove the console bracket and bolts.
  2. Position the wire harness assembly out of the way.
  3. Disconnect any electrical connectors.
  4. Transfer components as needed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.