SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2010VUE XE, 2.4 1REPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSKEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONSDIAGNOSTIC INFORMATION AND PROCEDURESKEYLESS ENTRY SYSTEM INOPERATIVECIRCUIT/SYSTEM TESTING
2010 Saturn Vue XE, 2.4 1

Circuit/System Testing

2010 Saturn Vue XE, 2.4 1SECTION Circuit/System Testing
  1. Verify that the transmitter is the correct transmitter for the vehicle.
    • If not the correct transmitter, replace the transmitter.
  2. Verify the scan tool FOB Programmed parameter for the appropriate transmitter is Yes.
  3. Place the transmitter on the test pad of the J 43241  and press each transmitter button one at a time, holding each button for three seconds. The tester should sound a tone and illuminate a green light for the entire three second button press.
    • If one or more buttons does not sound the tone and illuminate the green light for the entire three seconds, replace the transmitter battery and retest with the J 43241 . If the condition continues after battery replacement, replace the transmitter.
  4. Operate the transmitter while observing the scan tool Fob Function parameter for the appropriate transmitter. The parameter should correspond with the function selected on the transmitter.
    • If the parameter does not match the function selected on the transmitter, replace the transmitter.
  5. Attempt to program the transmitter, refer to Remote Control Door Lock Transmitter Programming . The transmitter should program.
    • If the transmitter does not program, test the keyless entry coax and/or antenna for a short to ground or an open/high resistance. If the circuit tests normal, replace the RCDLR.
  6. If all circuits test normal, replace the RCDLR.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.