Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN2010VUE XE, 2.4 1REPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSIMMOBILIZER SYSTEM
2010 Saturn Vue XE, 2.4 1
Immobilizer System
2010 Saturn Vue XE, 2.4 1SECTION Immobilizer System
- Schematic Wiring Diagrams
- Diagnostic Information and Procedures
- Diagnostic Code Index
- DTC B3006: Hood Ajar Circuit
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC B302A: Telematic Requested Immobilization
- DTC B3031: Security System Controller In Learn Mode
- DTC B3055: No Transponder Modulation or No Transponder
- DTC B3060: Unprogrammed Transponder Identification Code Received
- DTC B3935: Transponder Authentication Error
- DTC B3976: Unconfigured Transponder/Vehicle Configuration Not Programmed
- DTC P0513: Theft Deterrent Key Incorrect
- DTC P0633: Theft Deterrent Key Not Programmed
- DTC P1629: Theft Deterrent Key Not Programmed
- DTC P162B: Remote Vehicle Speed Limiting Signal Message Counter Incorrect
- DTC P1630: Theft Deterrent Learn Mode Active
- DTC P1631: Theft Deterrent Learn Mode Active
- DTC P1632: Theft Deterrent Fuel Disable Signal Received
- DTC P254F: Engine Hood Switch
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Action Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- Symptoms - Immobilizer
- Symptoms - Reduced Engine Power Message
- Hood Ajar Indicator/Message Malfunction
- Repair Instructions
- Description and Operation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.